hood deflector

Please enter the desired vehicle or
ask by mail and indicate your desired vehicle!

email: info@pakfeifer.com

The attachment is done with the help of clips and hooks.
The hooks must be hooked to the holes in the lower part of the bonnet or into the original holes of the fairing; It is especially recommended for longer trips, it protects the hood from weather, stones and the "burning" of the insects.

Attention!
The hood cover may only be mounted on a clean surface to prevent scratch marks of dust and stones.

The ears on the edge of the material prevent the fluttering of the plastic at higher speeds, so you always have to tighten the material firmly.
It is important that the plastic is properly attached.
It should only be placed over 15 degrees, and you must always make sure that the material is tight.
In summer, as a result of the heat, it may be necessary to tighten the ropes with the help of the ratchet.

Cleaning:
done with lukewarm water and a sponge.
The water, which runs between the plastic and the bonnet (even rain), dries very quickly.

It is recommended:
In winter, the plastic to mount on the car only when the car is in the garage, otherwise the water between the bonnet and plastic can freeze, and cause damage in the paint.

We are not liable for damage caused by improper installation or use!

Single production after entering the order / payment!
Delivery time max. 2 weeks !

The set includes:
The tension ratchets, the plastic top with felt, which helps that the dust can not come between the hood and the plastic.